 |
15' Ground Cord No. 793.15cord
Use the cord to connect all ESD tabletop and floor mats to a building ground. The solderless terminal can be connected to an electrical outlet using the screw in the outlet cover.
Specs
Uses: To connect all ESD mats to a building ground.
Construction: Molded-in male snap fastener on one end and solderless terminal on the other.
Resistivity: Integral one megohm resistor
Snap: Conforms to 10mm snaps
$9.50
Please order below!
|
|
|
Heel Grounder No. 793.HG
Made for workers wearing insulative shoes, the Heel Grounder allows static electricity to pass from the worker to the ESD matting or flooring. One size "fits all" and the Velcro® loop allows for easy attachment. Allow the fabric strip to touch the workers skin for best performance.
Specs
Uses: To allow shoes to conduct static discharge
Construction: Two-layer laminated rubber sole with Velcro® loop attachment
Resistivity: One-megaohm resistor
Width: 1.5"
Thickness: 0.060"
$9.75
One size fits all!
Please order below!
|
|
 |
Wrist Strap No. 793.6WStrap
For optimum effectiveness, use our 6’ Coil Cord and Wrist Strap to
ground workers to their ESD Workstation Mat tabletop mats. To complete the connection to a building ground, connect the coil cord to our 797.CPCord or simply clip to the grounding snap.
Specs
Uses: To ground the worker to the mat
Construction: One inch wide comfort strap with copper sulfide fibers, 6’ Coil Cord with snap on one end and a banana jack on the other. Separate alligator clip.
Resistivity: One megohm resistor
$9.75
Please order below!
|
|
 |
Common Point Ground Cord No. 797.CPCord
Equipped with dual jacks, our common point ground cord allows two wrist straps to be grounded at the same point to our ESD Workstation Mat tabletop mats. The molded-in male fastener snaps to table-top mats while the solderless terminal at the end of the 15’ cord connects to a building ground.
Specs
Uses: To achieve a common ground with the building, table-top mat and wrist strap
Construction: Molded-in male snap fastener (with two sockets to accommodate banana jacks)
Resistivity: No resistor necessary
Snaps: Conforms to 10mm snaps
Length: 15’
$11.50
Please order below!
|
|
|