|
|
|
|
|
The following Melt-Away Mat accessories are offered by leading manufacturers of snow sensors and temperature controls to help customers fully automate their products.
|
Thermostat (EH 38, manufactured by EasyHeat); 120V, 15 Amps
|
 |
The EH38 plugs directly into any 120V outlet, and then acts as an outlet receptacle itself. Once the EH38 is plugged in, a Melt-Away mat can plug directly into the back of the EH38 thermostat. When installed, the convenient EH38 automatically energizes the mat at temperatures lower than 38°F/ 3°C and then shuts off power when the temperature rises to 50°F/ 10°C. The EH38 has a power indicator light that lights up when the thermostat is energized. The EH38 is designed only for 120V products, and can handle up to 15 Amps.
|
Snow & Temperature Sensor (LCD-1, manufactured by ETI); 120V/240V, 16 Amps
|
 |
The LCD-1 snow switch is an energy saving alternative to thermostat, manual or timer controls. The LCD-1 operates the Melt-Away mats when precipitation occurs at temperatures below 38°F (3.3°C) and remains energized for 5 hours after precipitation stops to ensure complete ice/snow melting. The LCD-1 snow switch operates from 120Vac, 50/60 Hz. An integral relay rated for 120/240Vac 16 Amp loads permits direct heater control for small applications such as wheelchair ramps and stairways or may operate external contactors in large installations. The LCD-1 is hardwired into a circuit and is not a plug-and-play like the EH38. For best results, the LCD-1 should be mounted at least six feet off the ground with nothing hanging over it (i.e. an overhang, awning, etc.).
|
|
Snow & Temperature Control System for Large Applications (CIT-1 & APS-3B, manufactured by ETI)
|
|
The CIT-1/ APS-3B combination is meant for large applications of Melt-Away products. The CIT-1 is a snow and moisture sensor that is mounted at least six feet off the ground (with no overhang above it). The CIT-1 connects to the APS-3B controller through standard outdoor electrical conduits (not provided by allMATS), which is mounted on the side of the building near the application. Many circuits can then be wired into the controller to energize multiple mats that may lie on the circuit. We recommend consulting with a certified electrician for wiring.
|
 |
 |
|
|
| Product |
Price |
| EH 38 |
$35.00 |
| LCD-1 |
$204.00 |
| CIT-1 & APS-3B |
$1444.00 |
| CIT-1 |
$369.00 |
| APS-3B |
$1075.00 |
|
|
|