|
|
|
|
|
GripSafe Reflective Tape prevents mat movement even in the most heavily trafficked work areas. Designed for use on concrete (sealed or unsealed), terrazzo, tile or even vinyl, this sturdy tape will hold rubber and vinyl anti-fatigue mats in place. GripSafe can also be used to designate specific areas or pathways both inside and out. In can be adhered to asphalt and will withstand the abuse of car, truck and tow-motor traffic. For best results, clean the floor surface and allow it to dry before installation, then apply GripSafe to the lengths of the mat. If the mat is a large custom size or over 6' wide, it is best to use the tape on all sides. Available in rolls only. No custom sizes!
|
|
|
| Stock Sizes |
Price
|
| 4" wide x 45' |
$115.00 |
|
|
|
|
|
|
Ways to Prevent Mat Movement
Mats move, but this can be prevented. The amount of movement depends on the type of mat, the amount of foot traffic and the condition of the floor surface in the work environment.
The fact that mats move is a basic rule and can be explained by the principles of physics. The force of a human being moving forward in a walking gait tends to push any uninstalled floor surface forward. However, there are ways to stop or inhibit this movement.
- Install your mats. There are some matting products that are designed to be installed. ErgoDeck is an excellent example. Its wide edging has bolt holes to allow the mat to be permanently anchored to the floor.
- Buy sponge-backed mats with a higher underside coefficient of friction. This is especially important if your facility has smooth epoxy-covered floors. A natural rubber sponge is the best option in this case. Slip-Resistant Diamond-Plate was designed just for this specific situation. The rubber sponge will move much less than any other because its cell structure is exposed and the compound has a much higher COF.
- Tape the mats to the floor with an industrial strength tape. This is a good solution if you cannot tolerate any mat movement. In a high traffic area however, the tape may begin to fray after several months of usage and will need to be replaced.
- Adhere the mats to the floor using either a high quality rubber or vinyl glue. This is also an option if you are worried about any mat movement. Contact your local hardware store for the best rubber, vinyl or silicone glue.
|
|
|